As great and amazing as it is to install floor epoxy on to your concrete floor and get that elegant look on to it, some seem to find not great results. Some even creates a mess. So why this great damage repellent, gloss coated floor not work out for everyone?
First major mistake is the fact that the floor isn’t prepared properly, AKA poor surface preparation. Before you start doing anything on epoxy, make sure to have the floors clean and dry. The floor needs to be dust free as the substrate needs to grounded and shot blasted. Of course, you also need to make sure that if you are reapplying, to strip the previous coating properly.
Second would be the humidity, consider the season you are applying the epoxy. Humidity does not bond well with the epoxy products, therefore you will find it hard to coat. So make sure that the floor is completely dry and there are no pipe leakages and no humidity rising from the ground.
Next reason for the failure is the weak substrate. If the quality of the cement on your concrete floor is weeks than your epoxy floor product, then you will notice that the epoxy floors Melbourne will not work out for your floors will not attach the epoxy product. It’s not the epoxy that actually detaches from the cement, but the cement itself floor the cement.Another mistake would be the fact that not using of the proper primer or not using a primer at all. Floors go through very heavy tears and wear. We can’t expect such floor to be able to simply sick to the substrate. You will need a primer, which is suitable for the substrate. Even if your concrete is properly prepared, if the floor is contaminated due to things like fatty acids (from cooking) and acids (if this is a car service place).
This contamination avoid the epoxy product being sticked to the floor. So first up, you need clean up all the greasy oils and residue before you attempt to apply anything on floor. This should be taken note if you plan on epoxy flooring for factory and warehouses.Last but not least, if you don’t have the products mixed properly the coating will not be cured properly. So make sure to get professional help or follow written instructions properly. If you do as the instructions say, you may be able to get it right.Well, this are some common reasons for the failure. Hope you found what mistake you have made.